The following case: Quzhou Longyou Jinfeng International Trade Hotel

[Material]: ash frame
[Outer packaging]: wooden frame packaging
[Color]: Picture color (color can be customized)
[Inventory situation]: the customization cycle of conventional products is 7-10 days, and the customization cycle of customized products is 15-25 days, which is determined according to the quantity and manufacturing process of products.
[Maintenance instructions]: wipe the dust with a cleaning cloth stained with detergent or neutral soap solution to remove the dust. Pay attention to that the furniture cannot be soaked in water, exposed to the Sun, hit hard, etc.

  Contact number: 13735713828 WeChat: 13735713828

process supplementary note

  i. High temperature and high pressure cooking, air drying and steam drying. High temperature and high pressure cooking extracts high moisture content and residual glue juice in the wood. Steam drying makes the log reach the moisture content required for making furniture, and at the same time achieves the effect of sterilization and insect removal. The processed logs will not be deformed, moldy, decayed or insect-bearing, and the moisture content is basically below 12%. At this time, the wood surface mask has Luster, color uniformity, fine texture and medium structure.

  Second, drying is the first step in furniture manufacturing, and it is also a key step. How to deal? -- Steam drying treatment. The drying process is divided into three steps:

  1. Pre-heat treatment: it is mainly low temperature and high humidity to balance the temperature inside and outside the wood and reduce the moisture content initially;

 2. Drying stage: it mainly increases the temperature gradually, reduces the humidity slowly, extracts the water inside and outside the wood, and makes it reach the moisture content we want;

  3. End treatment: after retreatment, the wood is consistent inside and outside and can be at room temperature to eliminate the internal stress generated during the drying process. III. Machining 1. Wood batching processing

   after drying, the solid wood raw materials should be processed at the processing place of solid wood ingredients: a: cutting/cutting materials; B: digging saw; c: Plane planing/four-side planing/pressing planing; d: assembling; e: digging/longitudinal cutting saw/guide saw; f: milling machine; g:(Profiling) lathe; h: tenoning/drilling; I: Slot broaching/Engraving/sanding. Plate ingredients Processing: a: Ingredients/wood veneer/patchwork/patchwork; B: Rough cutting/clamp/framing; c: cold pressing/hot pressing; d; Fine cutting/edge binding/trimming; e: coarse sand light/fine sand; f: in-line/edge sealing; g: racket drill/bench drill; h: single end milling machine/double end milling machine; I: Processing Center/Sand cleaning/manual edge sealing.

 ① be firm, sentence, secret, flat and upright.

 ② pay attention to the moisture content of all solid wood parts and wood carving used must be strictly controlled.

 ③ bad phenomena such as bending deformation and cracking of all parts must be selected and dealt.

 ④ pay attention to the direction of wood grain such as panel, side panel, door panel and panel, and the matching between left and right patterns, and the colors should be as harmonious as possible.

 ⑤ when the half group is standing, check whether the mold is loose and worn.

 ⑥ when the group is set up, there should be no adverse phenomena such as reverse installation, wrong installation, violent nail, lock crack, dislocation, etc.

  Contact number: 13735713828 WeChat: 13735713828